 |
 |
| 1. Remove all the buckles and the trim panel. | 2. Remove the left and right hinge plastic trims as shown. |
 |
 |
| 3. Take out the luggage cover and remove the long trim of the original car lock frame. | 4. Remove the lock frame. |
 |
 |
| 5. Install our electric suction lock. | 6. The lock motor is placed on the right. |
 |
 |
| 7. Remove the buckle and remove the right trim of the original car velvet. | 8. Install our right bracket. |
 |
 |
| 9. Unplug the lock wire of the original car, and plug it with our lock control wire. | 10. As shown in the figure, route the lock control wire and the tailgate switch wire to the control box (ECU). |
 |
 |
| 11. Route the power cord to the main driving position. | 12. Find the fuse box under the steering wheel. |
 |
 |
| 13. Unplug the 20A, then plug in our fuse. | 14. Connect to the ground wire. Note: connect GND first, then power on. |
 |
 |
| 15. Insert the plugs into the control box (ECU). | 16. After installing the right side trim, you need to cut the trim with a utility knife to expose the bracket ball head, and then install the electric struts. |
 |
 |
| 17. Install our tailgate switch button. | 18. Restore all components and finish installation. |
